Share this post:

Know your Vuse eTank Mini

This device was tested using a 1.4 Ω (resistance) atomiser with battery operating mode of 3.7V using a 50/50 VG/PG eLiquid.

Quick Start

Ensure clearomiser is screwed firmly to the recharging unit by holding only the base of the clearomiser and recharging unit. Do not hold the clearomiser glass or top to screw together.

Fill the clearomiser with eLiquid, down the side of clearomiser wallto the atomiser shoulder, and wait 15 minutes. Replace clearomiser top after filling.

Carry out several 'dry puffs' (inhale through the clearomiser top without pressing control button) to draw liquid into the wick.

Click the control button 3 times within 2 seconds to unlock the device. Keep button pressed during vaping.


→ Fully charge your eTank Mini before first use to ensure optimal performance.

→ Ensure the eLiquid level does not drop below the atomiser shoulder to help prevent the wick from drying out whilst vaping.

→ Do not pour eLiquid down the central atomiser hole.

→ If there is sufficient eLiquid in the clearomiser and you notice a burnt after taste whilst using your eTank Mini, this means your atomiser has deteriorated and should be replaced. The atomiser is a replaceable element that deteriorates during its lifetime. The atomiser must be disposed of in compliance with national and local regulations.

→ At Vuse we always craft our eLiquids for the best possible vape tailored to our devices. This device should be used with Med VG Vuse eLiquids.

→ Your Vuse eTank Mini can be locked or unlocked by rapidly clicking the control button 3 times. This is to prevent accidental activation. Lock device when not in use.

How to fill your Vuse eTank Mini clearomiser 

Unscrew the clearomiser top.

Pour eLiquid down the inside of the tank wall, taking care not to get eLiquid into the central atomiser hole.

→ The maximum capacity of the clearomiser is 2ml. To avoid spillage, when filling, leave at least 2mm of space at the top of the clearomiser glass.

→ Screw the top back onto the clearomiser.

→ To ensure the top is replaced to the correct tightness, screw the top on until the vapour temperature control hole just fully closes. Finally, adjust the vapour temperature control hole according to preference.

How to charge your Vuse eTank Mini

Connect the recharging unit to the micro-USB cable and connect the micro-USB cable to the USB port or to the power socket using a 230V adapter (5V/0.5A).
Once your device is fully charged, it will automatically stop charging.


→ Disconnect the device from the power source once it has finished charging.

→ The device should only be charged using the Vuse micro-USB cable supplied with your kit.

When to change your Vuse eTank Mini atomiser

→ The atomiser should be changed regularly in line with frequency of use (typically every 2-4 weeks).

→ If you notice a deterioration in the quality of the vapour and there is sufficient eLiquid in the clearomiser, you should replace your atomiser - visit vuse.com to purchase Vuse eTank Mini atomisers.

How to replace your Vuse eTank Mini atomiser 

→ Ensure that your clearomiser is empty of any eLiquid.

→ Detach the clearomiser from the Vuse eTank Mini recharging unit.

→ Turn the clearomiser unit upside down. Hold the clearomiser glass and unscrew the atomiser base. Remove the atomiser and replace it with a new one.

→ Hold the clearomiser upside down to prevent the atomiser falling out. Re-attach the atomiser base by correctly aligning the screw thread and turning base 1 1/4 turns.

→ Re-attach the clearomiser to the eTank Mini device by turning the clearomiser base.

What to do if your Vuse eTank Mini stops producing vapour

→ Check the eLiquid level in your clearomiser and top up if necessary.

→ Check that your device is charged.

→ The build-up of dirt inside the bottom of your clearomiser may disrupt normal charging. To prevent this, check and if necessary detach your clearomiser from the eTank Mini and clean with a dry cloth to remove any build-up of dirt.

Important product use information

Never keep close to keys or coins.

Do not use around flammable liquids or gases.

Do not use if damaged.

Never leave in direct sunlight or near heat sources.

Keep Vuse products dry.

Store Vuseproducts in theideal temperature.

→  During prolonged use, device warming may occur. Please ensure regular and sufficient breaks between sessions.

→  Vuse eTank Mini contains a non-replaceable lithium-ion polymer rechargable battery.

→  Do not store the device long term if your eTank Mini battery is completely discharged as the battery will become unstable.

→  Vuse eTank Mini is recommended for use with medium VG Vuse eLiquids. Vapour quality and satisfaction may vary if used other than as recommended.

→  A build-up of dust, dirt or eLiquid inside your Vuse eTank Mini recharging unit and clearomiser may reduce performance. To minimise this, check regularly and if necessary wipe the connector with a clean, dry cloth.

→  When the device button is held down for longer than 10 seconds, the light around the button will flash 3 times and the device will be locked. Three fast clicks performed within 2 seconds will unlock the device.

→ Your eTank Mini device has overcharge and overdischarge short-circuit protection and idle timeout (after 10 minutes of inactivity).

→ The Vuse eTank Mini clearomiser is made from glass so should be handled carefully as it may break if dropped.

→ Do not use your Vuse eTank Mini if the coil within the atomiser has become flooded. If this occurs, clean your clearomiser and replace the atomiser.

→ Your eTank Mini device should be used at room temperature. If your device is operated outside of recommended temperatures, it may be damaged or stop working. (Charge: 5°C to 45°C, in-use: -10°C to 60°C).

Important safety information

→  Always use this product in accordance with these manufacturer’s instructions.

→  To avoid the risk of fire, injury and/or damage to your Vuse eTank Mini or other property, only charge your device with the equipment provided in your Vuse eTank Mini kit.

→  Immediately stop use of this product and seek medical advice if you experience any of the following: Development of an irregular heartbeat; allergic reaction such as rash, itching or swelling of the tongue, mouth or throat; feeling faint; nausea; headache; or any other unusual or adverse effect.

→  Never leave the eTank Mini unattended while charging.

→  Rating input of USB charging cable: 5VDC, 2A.

→  This product should only be connected to a safety extra-low voltage (SELV) circuit rated at 5V, 0.5A.

→  Children shall not play with the appliance. Cleaning and user maintenance shall not be carried out by children.

→  Do not drag, crush, pierce, incinerate or immerse in water, the device or USB charging cable.

→  Do not insert foreign objects into the device.

→  Protection provided by the equipment may be impaired if used in a manner not specified by the manufacturer.

→  Do not use e-cigarettes when you, or anyone in the vicinity, is using oxygen.

→  If you have any questions or doubts about the use of your Vuse eTank Mini or any other Vuse products, please contact the Vuse Customer Care Team.

This product is not suitable for use by

→ Persons under the age of 18.

→ Persons who are allergic/sensitive to nicotine and any other listed ingredients.

→ Pregnant or breast-feeding women.

→ Persons who should avoid using tobacco or nicotine products for medical reasons.

→ Persons with an unstable heart condition, severe hypertension or diabetes.

This product is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the product by a person responsible for their safety.

Disposal and recycling

Electrical and electronic goods and batteries should not be disposed of as part of regular household waste, but should be separately collected for recovery and recycling.

Electrical and electronic goods and batteries should not be disposed of as part of regular household waste, but should be separately collected for recovery and recycling.

A sign of quality you can trust 

Since it’s the vapour that you inhale and the vapour that delivers the satisfaction, it is very important for us to know exactly what our vapour contains. This is why we put so much care and research into every eLiquid and every product we make – to ensure purity of ingredients, consistent vapour quality and satisfaction from start to finish.So wherever you see this sign you know the vapour you inhale has been rigorously tested.

Call a POISON CENTRE or doctor/physicianif you feel unwell.

*Except zero nicotine products.

British American Tobacco UK Ltd., 4th Floor, Building 7 Chiswick Park, Chiswick High Road, London, W4 5YG, UK
T: +44 (0) 800 1337 350
Email: info.uk@vuse.com

Share this post:

Explore our other sections


Facts to tackle

  • Vaping vs smoking
  • Vaping myths
  • Vaping safety

Responsibility beyond product

Underage prevention and
vaping laws.

  • Vuse verify programme
  • Underage prevention
  • Vaping laws & TPD

Unpacking vaping for you

Information to guide
your vaping journey.

  • Vaping beginners guide
  • Nicotine strengths
  • Device types


Vuse testing and
quality standards.

  • Vuse quality standards
  • Vapour testing
  • Our science approach

Talking vaping with you

Got a question about
vaping? Just ask us.

  • Chat with us
  • Submit a question
  • Visit us in store


*By 'no tar' we mean no tobacco derived tar. This product is not risk-free and contains nicotine, an addictive substance